← Sesame Robot
Project files
- all-hardware.png279 KB
- battery-connector-solder.png1.5 MB
- display-soldering.png1.6 MB
- display-wires.png123 KB
- dont-mount.png362 KB
- femur-joints.png433 KB
- foot-joints.png246 KB
- insert-battery.png616 KB
- insert-display-enclosed.png203 KB
- insert-display.png386 KB
- insert-frame.png230 KB
- install-frame-motors.png325 KB
- joint-horn-install-2.png290 KB
- joint-horn-install.png208 KB
- joints-preassem.png273 KB
- press-on-bottom-cover.png467 KB
- push-on-top-cover.png663 KB
- reference-configuration.png345 KB
- remove-headers.png501 KB
- rotate-motor.png496 KB
- screw-on-bottom-cover.png303 KB
- secure-distro-board.png416 KB
- secure-distro-boardv2.png1.9 MB
- secure-electronics.png598 KB
- secure-top-cover.png395 KB
- securing-display-enclosed.png118 KB
- securing-display.png272 KB
- servo-install-leg.png413 KB
- sesame-angle-guide.png2.9 MB
- sesame-done.png2.2 MB
- switch-insert.png128 KB
- top-cover-wiring.png1.1 MB
- wire-routing.png1.8 MB
- wire-spot.png489 KB
- zip-tie-bundles.png1.5 MB
Files by @dorianborian, at commit d106cbc, read from GitHub in your browser. Hardware license: Apache-2.0; software license: Apache-2.0. Robotheca doesn't review code: read it before running it.