← Robotics 101
Project files
- 101-devkit.png211 KB
- all-components-2.jpg791 KB
- all-components.jpg885 KB
- almost-finished-robot.jpg844 KB
- arduino-disconnected.jpg988 KB
- arduino-screwed.jpg885 KB
- ball-wheel-on-chassis.jpg802 KB
- board-with-components.png14.5 MB
- board-with-servo.JPG612 KB
- breadboard-right-and-wrong.png317 KB
- breadboard-screwed.jpg952 KB
- button-circuit.png80 KB
- button-on-breadboard.jpg1.4 MB
- capacitor-polarity.png116 KB
- command-prompt.png11 KB
- corner.png50 KB
- cutty-draw.JPG11.7 MB
- done.png60 KB
- electronics-done.jpg2.3 MB
- electronics-schematic-labelled.png398 KB
- electronics-schematic.png407 KB
- electronics-test.jpg2.1 MB
- feed-in-solder.jpg829 KB
- finished-board.JPG1.8 MB
- finished-robot.jpg875 KB
- h-bridge-0.png7 KB
- h-bridge-1.png11 KB
- h-bridge-2.png11 KB
- header-pins.JPG413 KB
- heat-shrink-box.JPG21.7 MB
- heat-shrink.JPG338 KB
- holder done.png44 KB
- holding-iron.jpg1.1 MB
- ir-robot.png1.2 MB
- ir.png247 KB
- iron-heating.jpg1.3 MB
- jumper-wires-box.jpg2.3 MB
- jumper-wires.jpg92 KB
- led-circuit-off.jpg979 KB
- led-circuit-on.jpg1.1 MB
- LED-on-breadboard-schematic.png522 KB
- led-polarity.png41 KB
- logo.jpg65 KB
- many-wire-strippers.jpg777 KB
- motor-soldered.JPG1.0 MB
- motors-and-wire.JPG9.0 MB
- motors-in-chassis-1.jpg794 KB
- motors-in-chassis-2.jpg820 KB
- motors-with-heat-shrink.JPG9.0 MB
- overall.png96 KB
- screw_terminal.jpg1.2 MB
- shaft-adapter.jpg889 KB
- soldered-board.JPG10.2 MB
- soldering-area.jpg1.1 MB
- soldering-stations.JPG11.9 MB
- stripped-wire.JPG8.0 MB
- swapping-wheel-directions.png195 KB
- switch-in-chassis-1.jpg858 KB
- switch-in-chassis-2.jpg967 KB
- switch-schematic.png67 KB
- switch-soldered.JPG538 KB
- switch-unsoldered.JPG506 KB
- switch.jpg82 KB
- upload-speed.png83 KB
- warmup-joint.jpg507 KB
- wheel-directions.png962 KB
- wheels-going-on.jpg1.2 MB
- wire-in-motor.JPG1.1 MB
- wire-strippers.jpg864 KB
- wire.JPG10.1 MB
Files by @ICRS, at commit 3426405, read from GitHub in your browser. Hardware license: CC-BY-4.0; software license: CC-BY-4.0. Robotheca doesn't review code: read it before running it.