← T-Top
Project files
- amplifier-crimp.jpg82 KB
- amplifier-heat-shrink-tube.jpg176 KB
- amplifier-JST-PH.jpg31 KB
- amplifier-power-wires.jpg86 KB
- amplifier-twist.jpg218 KB
- amplifier-wires.jpg128 KB
- battery-charger-crimp.jpg30 KB
- battery-charger-ferrule.jpg42 KB
- battery-charger-JST-PHR-6-cable-crimp.jpg60 KB
- battery-charger-JST-PHR-6-cable-order.jpg83 KB
- battery-charger-JST-PHR-6-cable.jpg41 KB
- battery-charger-JST-VHR-2N-connector.jpg44 KB
- crossover-RJ12-flat-cable.jpg41 KB
- fan-crimp.jpg48 KB
- fan-heat-shrink-tube.jpg37 KB
- fan-JST-PH.jpg35 KB
- fan-without-sleeve.jpg47 KB
- fan-yellow-wire.jpg38 KB
- LED-crimp-tins.jpg29 KB
- LED-heat-shrink-tube.jpg28 KB
- LED-JST-PH.jpg35 KB
- led-strip-28.jpg39 KB
- led-strip-long-5.jpg116 KB
- led-strip-short-5.jpg35 KB
- LED-twisted-wire.jpg26 KB
- light-sensor-connector.jpg46 KB
- light-sensor-crimps.jpg43 KB
- light-sensor-wires.jpg48 KB
- limit-switch-connector.jpg27 KB
- limit-switch-crimps.jpg29 KB
- limit-switch-heat-shrink-tubes.jpg28 KB
- limit-switch-tabs.jpg34 KB
- power-switch-crimps.jpg36 KB
- power-switch-JST-PH.jpg40 KB
- power-switch-wires.jpg39 KB
- psu.jpg30 KB
- push-button-connector.jpg27 KB
- push-button-crimps.jpg29 KB
- push-button-heat-shrink-tubes.jpg58 KB
- push-button-wires.jpg54 KB
- robot-power-connector-female-heat-shrink-tube.jpg47 KB
- robot-power-connector-female.jpg52 KB
- slip-ring-cable-computer.jpg44 KB
- slip-ring-cable-dynamixel-control.jpg60 KB
- slip-ring-cable-ferrule.jpg30 KB
- slip-ring-ethernet.jpg67 KB
- slip-ring-mini-usb.jpg68 KB
- slip-ring-power-connector-female.jpg77 KB
- slip-ring-power-connector-male.jpg64 KB
- slip-ring-rs232.jpg35 KB
- slip-ring-usb-a.jpg74 KB
- soldered-LEDs.jpg21 KB
- speaker.jpg84 KB
Files by @introlab, at commit 8d1b471, read from GitHub in your browser. Hardware license: CC-BY-NC-SA-4.0; software license: GPL-3.0-only. Robotheca doesn't review code: read it before running it.